This was a practical application of using 3D-printing to fabricate replacements for obsolete parts. The center caps for Holden Commodores with steel rims is a good addition to crate a tidy standard looking vehicle. These parts were commonly available and many were probably thrown away when steel rims were upgraded to alloy wheels but now a set can be from $100 – $180. Continue reading Replacing Obsolete Parts
The fabrication of the motard bracket, to adapt the Aprilia RS-125 radial mounted caliper to the Honda CRM-250 front forks, is now complete and the results are quite pleasing.
The pick-off is now finished.
The linishing was completed using an abrasive “flap-wheel” with a little bit of hand finishing. Continue reading Pick-Off Finished
The toroidal pick-off from the previous post has been printed. Continue reading Toroidal Pick-Off Printed